CAN39er series - initialising

After programming and installation, or after disconnecting the battery, the 39 CAN bus alarm system must be initialized. This is done as follows:

• Connect all cables to the control unit, connecting the power cable last.
• Observe the LED: after a few blink codes, it will flash briefly approximately every 3 seconds.
• Then turn on the ignition (fully on, not just in the accessory position).
• The LED will flash rapidly for approximately 5-10 seconds and then turn off.
• Turn off the ignition. - Done!

Tags: no led after battery was disconnected, no function after battery was disconnected, no function after installation